Accessory Modules Menu - GE Interlogix Concord Security System Installation Instructions Manual

Beep Delay (0905)
This setting determines how long AVM access
beeps are delayed (0–300s, in 2-second intervals) at
the beginning of a 2-way audio session.
Access Code (0906)
This setting determines the code required to access
the audio verification module to start an audio ses-
sion. If no code is programmed, pressing * starts an
audio session.
Unit-ID (10000 thru 10015)
This menu lets you identify all connected bus
devices, view each Unit Number, view the Device
ID number, and configure other settings based on a
specific device. This menu also lets you delete
learned bus devices.
Note
Most settings under ACCESSORY MODULES—BUS
DEVICES have no shortcut numbers.
To help identify bus devices, the 8-digit Device ID
number is also located on a label on each Super-
Bus 2000 device.
53
¾
1.
2.
¾
1.
2.
¾
1.
2.

Accessory Modules Menu

The
ACCESSORY MODULES
• —this menu lets you read bus device unit numbers, assign bus devices to a par-
BUS DEVICES
tition, and configure other features associated with a specific bus device.
• —this menu lets you set the configuration number for each SnapCard output,
SNAPCARDS
assign SnapCard outputs to a partition, and name the SnapCard outputs.
The following procedure describes how to program the settings that appear under
MODULES—BUS DEVICES .
¾
1.
2.
¾
1.
2.
3.
Audio Verification-Partition 1(Default = 02 sec.)
To change the Beep Delay:
With the display showing
AUDIO VERIFY OFF/ON
the display shows
BEEP DELAY nn SECS
Enter the desired time. The display flashes the entered setting. Press
# and the display shows the new setting.
Audio Verification-Partition 1(Default = **** or none)
To change the Access Code:
With the display showing
AUDIO VERIFY OFF/ON
the display shows
ACCESS CODE nnnn
Enter the desired 4-digit access code. The display flashes the
entered code. Press # and the display shows the new setting.
To delete an Access Code:
With the display showing
AUDIO VERIFY OFF/ON
the display shows
ACCESS CODE nnnn
Press D to delete.
menu gives you access to the following menus:
Acc. Modules-Bus Devices (Default = **** or none)
To identify bus device Unit and ID:
With the display showing
BUS DEVICES
the bus Unit Number and the 8-digit Device ID number. For exam-
ple: . Where
UNIT - ID 0—02110185
is the Device ID number.
Press A or B to identify all other bus Unit Numbers (0–15) and
Device ID numbers.
To delete learned Unit Numbers:
With the display showing
BUS DEVICES
the bus device set to Unit Number 0.
Press A or B until the bus device Unit Number you want to delete is
displayed.
Press D. The display changes the Unit Number to
, press A or B until
(current setting).
, press A or B until
(current code).
, press A or B until
(current code).
ACCESSORY
, press #. The display shows
is the Unit Number and
0 02110185
, press #. The display shows
.
NONE
Concord