GE Interlogix Concord Security System Installation Instructions Manual page 49

Concord security system;

Table of Contents

Battery Restoral (06005)

If this setting is on, the panel reports to the central monitoring sta-

tion when a wireless sensor or touchpad reports a battery replace-

ment to the panel.

Buffer Full Rpt (06006)

When this setting is on, the panel sends an "event buffer full" report

to the central monitoring station when the event buffer is nearly

full.

Zone Restorals (06007)

When this setting is on, the panel reports a restoral to the central

monitoring station for wireless or hardwire zones in alarm before

the alarm is canceled.

Note

As with all GE Interlogix panels, hardwire smoke detectors connected to

Concord or SnapCard hardwire zones do not send restorals.

Two Trip Error (06008)

This setting works with the Alarm Verify setting (see "Alarm Ver-

ify" later in this section and Appendix B: Table B1 "Sensor Table

Characteristics"). If Alarm Verify is on, then the panel waits for a

second sensor trip before sending an alarm.

Note

For UL Listed installations, the Two Trip Error feature must be set to off.

If Two Trip Error is also on and a second sensor trip does not occur

within a 4-minute time period, then the panel sends an error report

to the central monitoring station.

TP Panic RPT FMT (06009)

This setting determines how the panel formats touchpad panic alarm

reports to the central station.

When this feature is turned on, touchpad panic alarms report using

the following 3-digit codes:

Auxiliary—597, Police—598, Fire—599

When turned off, touchpad panic alarms report using a 3-digit code

from 500 to 515, with the last digit identifying the touchpad device

number.

Concord