GE Interlogix Concord Security System Installation Instructions Manual page 36

Phone Number (cs phone 1: 0100, cs phone 2: 0110,
cs phone 3: 0120)
This setting is used for programming the central station receiver phone number.
Phone numbers can be 1 to 24 digits long, including pauses or * and # characters.
To enter pauses, press C.
To enter *, press and hold 7 for about two seconds.
To enter #, press and hold 9 for about two seconds.
Note
The menus are not accessible if a Dealer Code is programmed and the
PHONE NUMBER
Installer Code is used to enter installer programming mode. To access these menus
when a Dealer Code is programmed, you must enter installer programming mode using
the Dealer Code.
Call-waiting services should be disabled to prevent interrupting panel communication to
the central monitoring station. To program a dialing prefix that disables call-waiting, see
the Call Wait Cancel setting under the menu
For UL 1610 & 1635 installations, a phone number must be programmed.
High Level Rpts (cs phone 1: 0101, cs phone 2: 0111,
cs phone 3: 0121)
When this setting is on, the following conditions report to the central sta-
tion:
• Fire, Police, Auxiliary, and Duress alarms
• No Activity
• Receiver Failure (or jam)
• Tamper conditions, including Zone Tampers and System Tamper (40
incorrect key presses or touchpad supervisory)
• Entering or exiting Sensor Test mode
• Phone Test
Note
For UL 1610 & 1635 installations, this feature must be set to on.
Low Level Rpts (cs phone 1: 0102, cs phone 2: 0112,
cs phone 3: 0122)
When this setting is on, the following non-alarm conditions report to the
central station:
• Force Armed
• Hardwire Zone Trouble (open or short)
• Supervisory (wireless devices)
• Low Battery (wireless devices)
• Phone Test
• Other non-alarm related conditions
Note
For UL 1610 & 1635 installations, this feature must be set to on.
31
PHONE OPTIONS—GLOBAL
.
Phones-CS 1-3 (Default = none)
¾
To program a Central Station Phone
Number:
1. With the display showing
(or current number), enter
NUMBER _
the desired phone number. The display
flashes the entered number.
2. Press # and the display shows the new
number.
¾
To delete a Central Station Phone
Number:
Š
With the display showing
(current number), press D.
NUMBER
The display shows
Phones-CS 1-3 (Defaults:1 = on, 2&3 = off)
¾
To turn High-Level Reports off or on:
1. With the display showing
(current setting), press 1 (off) or 2
OFF/ON
(on). The display flashes the entered setting.
2. Press # and the display shows the new set-
ting.
Phones-CS 1-3 (Defaults:1 = on, 2&3 = off)
¾
To turn Low-Level Reports off or on:
1. With the display showing
(current setting), press 1 (off) or 2
OFF/ON
(on). The display flashes the entered setting.
2. Press # and the display shows the new set-
ting.
PHONE
PHONE
.
HONE NUMBER _
P
HIGH LEVEL RPTS
LOW LEVEL RPTS
Concord