Reporting Menu - GE Interlogix Concord Security System Installation Instructions Manual

Concord security system;

Table of Contents

Star Is No Delay (partiton 1: 0514, partition 2: 0524)

This setting determines whether the keychain touchpad star button

controls an output (off) or the No Delay feature (on).

24-Hour Tamper (06000)

When this setting is on, the panel sounds sirens and reports a tamper

alarm (even when the system is disarmed), when wireless sensor

tamper switches are activated.

Note

For commercial UL Listed installations (UL 1610) the 24-Hour Tamper

must be set to on.

Buffer Control (06001)

When this setting is on, only arming level changes are logged in the

buffer (memory) of the panel. When this setting is off, all system

events are logged in the buffer.

Back In Service (06002)

When this setting is on, the panel reports to the central station when

AC and backup battery power are restored (after an extended power

outage).

Bypass Reports (06003)

When this setting is on, the panel reports to the central station

whenever sensors or zones are bypassed.

Low CPU Battery (06004)

When this setting is on, the panel reports a low panel battery to the

central station before shutting down.

Note

For UL 1635 listed installations, the Low CPU Battery feature must be

set to on.

Reporting Menu

The

menu lets you set up which system events are reported to the central monitoring

REPORTING

station. The following describes how to program the reporting settings that appear under

Touchpad Options-Partitions 1-2 (Default = off)

To change the keychain Star Is No Delay setting:

With the display showing

(current setting), press 1 (off) or 2 (on). The display

flashes the entered setting.