Programming Tier 2 Menu Items; Using Shortcut Numbers; Security Menu - GE Interlogix Concord Security System Installation Instructions Manual

Downloader Code (0000)
Downloader Code (0000)
The 5-digit downloader code is used in conjunction with downloader pro-
gramming. The down-loader operator must have the panel account number
and downloader code in order to perform any programming.
Note
The Downloader Code cannot be deleted from panel memory. To change the
Downloader Code to its default setting, enter 12345 in the procedure to the right.
The Downloader Code will be reset to defaults during a Memory Clear only if the
Dealer Code is not set OR if the Dealer Code is used to initiate the Memory Clear.
Installer Code (0001)
The 4-digit installer code is used for entering program mode and changing
system settings. If a dealer code is programmed, only those settings not
associated with phone numbers can be changed.
Note
The Installer Code cannot be deleted or cleared from panel memory. To change
the Installer Code to its default setting, enter 4321.
27

Programming Tier 2 Menu Items

This section guides you through programming tier 2 menu items as they appear in sequence.
Figure 31 shows the menus available on tier 2.
Each menu on tier 2 represents a group of settings related to the menu name. Some tier 2 menus
break down into settings that affect the whole system (global) or a specific partition.

Using Shortcut Numbers

To go directly to a setting in tier 2, you can enter the shortcut number for that setting. Shortcut
numbers in this manual appear in parenthesis ( ), next to the setting name. The menu appears to
the right. For example this heading shows the Downloader Code shortcut to be 0000.
Shortcut numbers can be used from any setting location within tier 2.
¾
To advance to tier 2 program menus:
Š
With the system in program mode and the display showing
once. The display should show

Security Menu

The menu lets you choose whether security settings affect the whole system (global) or
SECURITY
a specific partition.
¾
To access global or partition security menu items:
1. With the display showing
2. Press # again to advance to global settings, or press A or B to display
# to advance to selected partition 1 or 2 settings.
The following describes how to program the security settings that appear under
.
SECURITY
, press #. The display should show
SECURITY
¾
To program a Downloader Code:
1. With the display showing
CODE nnnnn
5-digit code, + ƒ . The display flashes the
entered code.
2. Press ƒ and the display shows the new
code.
¾
To program a Installer Code:
1. With the display showing
(current code), enter the desired 4-digit
nnnn
code. The display flashes the entered code.
2. Press # and the display shows the new code.
System Programming
SYSTEM PROGRAMMING
.
GLOBAL
, then press
PARTITION n
GLOBAL
Security-Global (Default = 12345)
DOWNLOADER
(current code), enter the desired
Security-Global (Default = 4321)
INSTALLER CODE
, press #
.
Concord