Programming The Cash Register Via The Pc; Installing The Pc Software - Olympia CM 940-F Operating And Programming Manual

5

Programming the Cash Register Via the PC

It is possible to programme the cash register using a PC as an alternative to programming it manually (see Chapter 6).
The following accessories are enclosed with the cash register to enable this:
a USB cable to connect the cash register to the PC and
●
a data CD with the recommended PC programme Olympia ECR Management System.
●
We recommend you only programme the cash register using Olympia ECR Management System. This can
Note:
considerably simplify programming various cash register settings and provides a clearer overview of the
programmed data because you can view it quickly, simply and clearly on the monitor screen. You can also
save the programmed settings so that, in the event of a system reset, you have a backup copy available
which you only need to transfer from the PC to the cash register.
Follow the instructions below in the sequence in which they are described!
Note:
5.1

Installing the PC software

Install the software before connecting the USB cable!
Note:
1. Insert the data CD in the PC.
2. Wait until the CD content is displayed on the monitor screen.
3. Open the SetupEcrSystem folder (see Fig. 4).
Fig. 4
4. Double-click on the SetupEcrSystem programme contained in it to install the PC programme.
5. Follow the instructions which appear on the screen:
Click on NEXT,
●
Confirm the path by clicking on NEXT,
●
Confirm again by clicking on NEXT.
●
- Continued on next page -
Olympia 2011
Cash Register CM 940-F / 941-F / 942-F
Page 22 Specifications subject to change without notice!