Programming The Training Pass Code - Olympia CM 940-F Operating And Programming Manual

6.13

Programming the training pass code

You can enter a 6-digit password (pass code) for Training mode which must then be entered each time a clerk wants to
operate the cash register in Training mode.
123456 should be programmed as the training code.
Example:
1. Set the key to PRG.
2. Select programme number 11
(see Chapter 6.1.2).
Press the ┣CASH┫ key to confirm
3.
the selection.
4. Enter the existing code (default
setting 000000) in the TRAINING
CODE input area.
Note:
Press the ┣CASH┫ key to confirm
5.
the input.
6. Enter a new 6-digit code in the
NEW CODE input area (digits
only).
Press the ┣CASH┫ key to confirm
7.
the input.
8. Repeat the pass code input in
the CONFIRM CODE input area.
Press the ┣CASH┫ key to confirm
9.
the input.
10. Conclude clerk programming by
pressing the ┣SUB-TOTAL┫ key.
Olympia 2011
Cash Register CM 940-F / 941-F / 942-F
Always enter the pass
code as a 6-digit number!
Input
Page 71 Specifications subject to change without notice!
Display
=PASS CODE
TRAINING CODE
New CODE
****** TRAINING CODE
****** New CODE
****** Confirm CODE
Save...!!
Please Continue...
1 =