Programming Rounding; Programming Rounding For Received On Account/Paid Out And For Calculating Tax; Programming Rounding For Receiving On Account / Paid Out - Olympia CM 940-F Operating And Programming Manual

6.32

Programming rounding

The cash register always rounds the totals after pressing the ┣SUB-TOTAL┫ and ┣CASH┫ keys.
6.32.1

Programming rounding for received on account/paid out and for calculating tax

You can define whether calculations for receiving on account / paying out and for tax should be rounded up or down after
selecting the type of rounding required.
If no special European rounding methods are selected, the standard commercial 5/4 rounding is applied:
If the first decimal place to be rounded is a 0, 1, 2, 3 or 4, the number is rounded down.
●
If the first decimal place to be rounded is a 5, 6, 7, 8 or 9, the number is rounded up.
●
6.32.1.1

Programming rounding for receiving on account / paid out

Significance
Always round down
Rounding (according to rounding method selected)
Always round up
An amount received on account or paid out should always be rounded up.
Example:
1. Set the key to PRG.
2. Select programme number 50
(see Chapter 6.1.2).
Press the ┣CASH┫ key to
3.
confirm the selection.
4. Enter the rounding code using
the digit keys.
5. Save the programmed data by
pressing the ┣CASH┫ key.
6. Conclude programming by
pressing the ┣SUB-TOTAL┫ key.
Olympia 2011
Cash Register CM 940-F / 941-F / 942-F
Page 109
Input
Specifications subject to change without notice!
Rounding code A
0
1
2
Display
=ROUNDING PO-RA%- 1=
[0]
[2 ]
Save...!!
Please Continue...