Configuring Auto VoIP (CLI)
This section provides information about the commands you use to configure
Auto VoIP settings on the switch. For more information about the
commands, see the
Switches CLI Reference Guide
Mapping Table Configuration
Beginning in Privileged Exec mode, use the following commands in to enable
Auto VoIP and view its configuration.
CLI Command
configure
switchport voice detect auto
exit
exit
show switchport voice
Dell Networking N2000, N3000, and N4000 Series
at support.dell.com/manuals.
Description
Enter Global Configuration mode.
Enable the VoIP Profile on all the interfaces of the
switch. You can also enter Interface Configuration
mode and use the same command to enable it on a
specific interface.
Exit to Global Configuration Exec mode.
Exit to Privilege Exec mode.
Show the status of Auto-VoIP on all interfaces or on
an interface, if one is specified.
Configuring Auto VoIP
1335