Dell Networking N4000 Series Configuration Manual page 1413

Command
ipv6 pim bsr-candidate vlan
vlan-id hash-mask-length
priority
[ ] [interval
ipv6 pim rp-candidate vlan
vlan-id group-address/prefix-
interval
length
[interval
ipv6 pim rp-address
address group-address/prefix-
length
[override]
Purpose
Configure the switch to announce its candidacy as a
bootstrap router (BSR)
interval
]
vlan-id
•
hash-mask-length
•
be ANDed with the group address before the hash
function is called. All groups with the same seed
hash correspond to the same RP . For example, if this
value is 24, only the first 24 bits of the group
addresses matter. This allows you to get one RP for
multiple groups. (Range 0–32 bits).
priority
•
BSR with the higher priority is preferred. If the
priority values are the same, the router with the
higher IPv6 address is the BSR. (Range 0–255).
interval —
•
advertisement interval. The range is from 1 to 16383
seconds. The default value is 60 seconds.
Configure the router to advertise itself to the BSR
router as a PIM candidate Rendezvous Point (RP) for
] a specific multicast group range.
vlan-id
•
group-address/prefix-length
•
and prefix length supported by RP .
interval
•
advertisement interval. The range is from 1 to 16383
seconds. The default value is 60 seconds.
rp-
(Optional) Statically configure the RP address for one
or more multicast groups. Only one RP address can be
used at a time within a PIM domain
The optional keyword override indicates that if there
is a conflict, the RP configured with this command
prevails over the RP learned by BSR.
— A valid VLAN ID.
— The length of a mask that is to
— The priority of the candidate BSR. The
(Optional) Indicates the BSR candidate
— A valid VLAN ID.
— (Optional) Indicates the RP candidate
Managing IPv4 and IPv6 Multicast
— Group IPv6 address
1413