Stage 9C. Fitting Small Office Edition Trunk Cards - Avaya 4600 Series Installation Manual

S tage 9c. Fitting Small Office Edition Trunk Cards
1 1 6 B
The Small Office Edition control unit can be fitted with a WAN card, a Quad BRI card or a single PRI/T1
card.
Procedure
1. Ensure that you wear an anti-static wrist strap that is connected to a suitable grounding point.
2. Remove the top cover (1) from the base cover by removing the four retaining screws (2) on either
side.
3. Remove the rear panel (3).
4. Locate the holes for the two trunk card spacer pegs and insert them.
5. Plug the trunk card (5) onto its sockets and stand-off hex. pillars.
•
If fitting a WAN card, replace the rear panel with the new one supplied with the WAN card.
•
Otherwise, on the rear panel, press out all of the knock-out panels (4) to match the trunk
card being fitted.
4. Replace the rear panel.
5. Fit the top cover back in place and reinsert the four screws previously removed.
12. Proceed to Stage 12. Upgrading the Core Software.
Installation Manual
IP Office 3.2 15-601042 Issue 14b (13th November 2007)
A. Basic Installation
Page 95