Adding A Wan3 Module - Avaya 4600 Series Installation Manual

IP Office Installation

1 2. Adding a WAN3 Module

6 6 B
This module is supplied with a LAN interconnect cable and a power supply unit. An appropriate locale
specific power cord for the power supply unit, and cables for the WAN ports on the rear of the module
must be ordered separately.
Installation Requirements
1. Installation space either on or under the existing IP Office control unit.
2. Switched power outlet socket.
3. System password.
4. IP Address
For the WAN module, on the same subnet as the control unit.
5. Free LAN port on the front of the control unit.
6. Grounding Requirements
1. Functional Ground.
Connection of a functional ground is recommend for all modules.
Tools Required
1. Manager PC.
2. DHCP server (preferably the IP Office itself).
3. Tools for rack mounting (optional).
Parts and Equipment Required
1. WAN3 10/100 Module
Each module is supplied with a suitable external power supply unit and a RJ45-RJ45 LAN
interconnect cable.
2. For the IP412 control unit an RJ45-RJ45 LAN crossover cable is required.
3. WAN Cables.
A V.24, V.35 or X.21 WAN cable is required for connection to each WAN port. The cable used
determines the signalling provided by that port.
4. Power cord for the power supply unit.
5. Rack mounting kit (optional).
6. Cable labeling tags.
Installation Manual
IP Office 3.2
WAN3 expansion modules connect to the IP Office control unit using a
LAN cable. It is preferred that the cable is connected directly to the IP
Office control unit rather than via any other equipment. A green 1 meter
(3'3'') LAN interconnect cable is supplied with the module for this purpose
though a replacement cross-over cable is required if connecting to an
IP412 control unit.
The WAN3 module requires its own IP address on the same subnet as
the IP Office control unit. A WAN3 module obtains that address using
DHCP so a DHCP server is required for installation.
15-601042 Issue 14b (13th November 2007)
Page 100