Trunk Cards - Avaya IP Office Essential Edition Installation Manual

1.6 Trunk Cards

IP500 Analog Trunk Daughter Card
IP500 PRI-U Trunk Daughter Card
PARTNER Version Installation Manual
IP Office Essential Edition
The IP500 base cards can be fitted with an IP500 daughter cards to
support the connection of trunks to the base card.
Each daughter card is supplied with the stand off pillars required for
installation and a label to identify the daughter cards presence on the
front of the base card after installation.
· IP500 Combination cards are pre-fitted with a trunk daughter card
which cannot be removed or changed for another type of trunk
daughter card.
This card allows the base card to support 4 analog loop-start trunks.
· The analog phone ports do not include a ringing capacitor. Where
this is a requirement, connection should be via a Master socket
containing ringing capacitors.
· If fitted with an IP500 Analog Trunk daughter card, during power
failure phone port 8 is connected to analog trunk port 12.
· Maximum: 3 per IP500 control unit.
This card allows the base card to support 1 PRI trunk connections.
The card is available in single and dual port variants. The card can be
configured for T1 robbed bit or T1 PRI.
· Maximum: 1 per IP500 control unit.
System Overview: Base Cards
Page 15
- Issue 1c (09 April 2010)