So8 Example 2: Video Conference - Avaya 4600 Series Installation Manual

IP Office Installation
S o8 Example 2: Video Conference
1 2 9 B
In this example, calls are routed to a Polycom Viewstation module connected to a S0 port of the IP Office
system.
The following settings were used on 4 incoming data channels of a PRI line:
•
Line Number: 5
•
Channel Allocation: 23 ->
1
•
Switch Type: 5ESS
•
Line Sub Type: PRI
•
Provider: AT&T
•
Channels: 1-4
To route an incoming video call on the PRI lines configured above to an SO8 module requires the
following:
1. Create a dial short code that has the SO port as its destination Line Group. For this example the
following was used:
•
Short Code: 1500
•
Number: .
•
Feature: Dial
•
Line Group: 601 (the SO8 port number)
2. Create an Incoming Call Routing that routes the appropriate calls to that short code. For this
example the following was used:
•
Line Group: 95 (identifies calls using the PRI lines configured above)
•
Destination: 1500 (the short code created above)
•
Bearer: Any
To allow the video device on the S0 port to make outgoing calls to the PRI lines also requires a short
code.
1. For this example the following was used:
•
Code: 91N;
•
Number: N
•
Feature: Dial
•
Line Group: 95
Installation Manual
IP Office 3.2
•
Incoming Line Group: 95
•
Outgoing Line Group: 95
•
Direction: Bothway
•
Bearer: Data
•
Service: Accunet (this is a important)
•
Admin: In Service
15-601042 Issue 14b (13th November 2007)
Page 158