Procedure: Rack Mounting
1. Using the small screws (2), fix the main brackets (6) to the module.
2. Using the nut (5), bolt (3) and washer (4) provided, loosely fit the module into the rack system in
its intended position.
3. If required, add the cable guide brackets (7) before finally tightening the nuts and bolts.
4. If required, connect the module ground points to the rack ground point. This should be done
using 14AWG solid wire with either a green sleeve (functional ground) or green and yellow sleeve
(protective ground).
5. Continue installation and setup as normal.
Installation Manual
IP Office 3.2
15-601042 Issue 14b (13th November 2007)
A. Basic Installation
Page 97