Avaya 4600 Series Installation Manual page 80

IP Office Installation
0 3. Control Unit Power Up
5 7 B
This procedure starts a new IP Office control unit without the unit being connected to any LAN. In this
scenario the IP Office control unit will assume its default configuration settings.
Objective
To power up the IP Office control unit to a known state with a known set of defaults.
Parts and Equipment Required
1. Switched power outlet socket.
2. IP Office Control Unit.
All control units are supplied with an external power supply unit.
3. Locale Specific Power Cord.
4. LAN Cable.
•
IP Office Small Office Edition, IP403, IP406 V1 and IP406 V2 Control Units: A standard
RJ45-RJ45 LAN cable can be used.
•
IP412 Control Unit: A RJ45-RJ45 cross-over LAN cable is required.
Procedure
1. Remove the control unit from its box and check its condition. Check that an external power
supply unit has been included with the control unit.
2. Connect the external power supply unit to the control unit.
3. Connect the power cord from the power supply outlet to the external power supply unit.
4. Switch on power to the control unit.
5. Observe the center LED on the front of the control unit (on the far-right on a Small Office Edition
control unit). Initially this LED will be red. After approximately 10 seconds it should change to
green. During this time other LED's may flash as the unit goes through its power on self test
cycle.
6. Proceed to 04. Receiving the Configuration.
Installation Manual
IP Office 3.2 15-601042 Issue 14b (13th November 2007)
Page 80