E1R2 Pri Trunk Cards - Avaya 4600 Series Installation Manual

IP Office Installation
E 1R2 PRI Trunk Cards
1 5 6 B
These cards support E1 trunks with R2 signalling. Each trunk provides up to 30B+D channels.
E1R2 PRI trunk cards are available with either RJ45 or coaxial cable connectors.
E1R2PRI trunk Cards
IP400 PRI 30
E1R2 RJ45
IP400 PRI 60
E1R2 RJ45
IP400 PRI 30
E1R2 COAX
IP400 PRI 60
E1R2 COAX
•
These cards include two plastic spacer pegs for installation and a replacement blanking plate for
the rear of the control unit. The blanking plate is not required with the Small Office Edition which
has removable sections in the rear panel.
•
For E1R2 coaxial card, a ground-jumper cable and coaxial connector locking rings are also
included.
E1R2 coax trunk cards must be grounded correctly and require the IP Office control unit to be connected
to a protective ground. Normally the ends of one connection is grounded. For example, if the exchange
Tx1 is grounded, the IP Office Rx1 should also be grounded. However this must be confirmed with the
line provider to establish which ends they want grounded.
1. Connect the ground strap spade end (B) supplied with the card to the spade connection on the
card and the other end (C) to the chassis with the long securing screw also supplied with the
card.
2. Use the two jumpers supplied with the card, match the ground selection of the line provider. For
example, if the line provider has grounded their Tx1, place a jumper across the two Rx1 pins of
jumper block J6.
Installation Manual
IP Office 3.2
Country
CALA, Korea, Supported on all control units except
China
CALA Supported only on the IP412 and
15-601042 Issue 14b (13th November 2007)
Control Unit
the Small Office Edition.
Slot A of the IP406 V2.
SAP Code
700241631
700241649
700241656
700241664
Page 196