IP Office Installation
1 3. Shelf/Wall Mounting (SOE)
6 7 B
Small Office Edition control units can be shelf or wall mounted. Four screw head retaining slots are
moulded into the base of the unit for this purpose. In addition a plastic Z-shaped bracket and screw is
supplied with the unit for securing it in position.
Installation Requirements
•
Horizontally on a shelf - leaving sufficient space for the cabling at both front and rear of the unit.
•
Vertically from a wall – with the front panel facing down only.
•
The Z-shaped bracket must not be used as the sole mounting fixture.
Tools Required
1.
Drill and drill bits suitable for the wall fixings selected.
2.
Screwdrivers.
Parts and Equipment Required
1.
Wall fixings suitable for 3 No.8 screws.
2.
3 x No.8 panhead screws, minimum 25mm long.
Installation Manual
IP Office 3.2
15-601042 Issue 14b (13th November 2007)
Page 102