Adding A Wan3 Module - Avaya IP Office Installation Manual

6.12 Adding a WAN3 Module

This module is supplied with a LAN interconnect cable and a
for the power supply unit, and
Installation Requirements
1. o Installation space either on or under the existing IP Office control unit.
2. o Switched power outlet socket.
3. o System password.
4. o Free LAN port on the front of the control unit.
5. o Grounding Requirements
5.1.o Functional Ground - Connection of a
Tools Required
1. o Manager PC.
2. o DHCP server (preferably the IP Office itself).
3. o Tools for rack mounting (optional).
Parts and Equipment Required
1. o WAN3 10/100 Module
Each module is supplied with a suitable external power supply unit and a RJ45-RJ45 LAN interconnect cable.
2. o For the IP412 control unit an RJ45-RJ45 LAN crossover cable is required.
3. o WAN Cables.
A V.24, V.35 or X.21 WAN cable is required for connection to each WAN port. The cable used determines the signalling
provided by that port.
4. o Power cord for the power supply
5. o Rack mounting kit (optional).
6. o Cable labeling tags.
IP Office Installation
IP Office
cables for the WAN ports on the rear of the module must be ordered separately.
functional ground
unit.
IP400 Basic Installation: Adding Expansion Modules
WAN3 expansion modules connect to the IP Office control unit
using a LAN cable. It is preferred that the cable is connected
directly to the IP Office control unit rather than via any other
equipment. A green 1 meter (3'3'') LAN interconnect cable is
supplied with the module for this purpose though a replacement
cross-over cable is required if connecting to an IP412 control
unit.
The WAN3 module requires its own IP address on the same
subnet as the IP Office control unit. A WAN3 module obtains
that address using DHCP so a DHCP server is required for
installation.
power supply unit. An appropriate
is recommend for all modules.
locale specific power cord
15-601042 Issue 19l (06 November 2008)
Page 113