Configuring Dhcp Vlan Settings - ZyXEL Communications GS3700 Series User Manual

38.5 Configuring DHCP VLAN Settings

Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients.
Click IP Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the
DHCP Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch. See
information on how to do this.
Figure 214 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 172 IP Application > DHCP > DHCPv4 > VLAN
LABEL
VID
DHCP Status
Server
Client IP Pool
Starting
Address
Chapter 38 DHCP
DESCRIPTION
Enter the ID number of the VLAN to which these DHCP settings apply.
Select whether the Switch should function as a DHCP Server or Relay for the specified
VID. If you select Server then fields related to DHCP relay configuration are grayed out
and vice versa.
Use this section if you want to configure the Switch to function as a DHCP server for this
VLAN.
Specify the first of the contiguous addresses in the IP address pool.
GS3700/XGS3700 Series User's Guide
Section 6.5 on page 58
321
for