Selection Of Operation Mode - Toshiba VFNC3-2001P Instruction Manual

efesotomasyon.com -Toshiba inverter,drive,servo,plc
5.5

Selection of operation mode

 : Command mode selection
 : Frequency setting mode selection
• Function
These parameters are used to specify which input device (operation panel, terminal board, or RS485
communication) takes priority in entering an operation stop command or frequency setting command
(terminal block VI, setting dial 1 (storing by pressing center of setting dial), RS485 communication, or
UP/DOWN from external contact).
<Command mode selection>
Title

5
Programmed value
:
:
:
* There are two types of function: the function that conforms to commands selected by , and the function
that conforms only to commands from the terminal board. See the table of input terminal function selection in
11.6.
* When priority is given to commands from a linked computer or terminal board, they have priority over the
setting of .
<Frequency setting mode selection>
Title

Function
Command mode selection
Terminal board
ON and OFF of an external signal Runs and stops operation.
operation
Panel keypad Press the
operation
Operation can also be done from the extension panel.
RS485
Run/stop operations from an external device.
communication
Function
Frequency setting mode selection
Adjustment range
0: Terminal board
1: Panel keypad (including remote keypad)
2: RS-485 communications
RUN
and STOP keys on the panel keypad to run and stop.
Adjustment range
0: Terminal board VI
1: Setting dial 1 (press in center to save)
2: Setting dial 2 (saved even if power is off)
3: RS485 communication
4: -
5: UP/DOWN from external logic input
E-10
E6581595
Default setting
1
Default setting
2