Notes Before Operating The Server; Auto-Run Function From Cd/Dvd Drives; Drive Letter Assignment In The Expert Mode - Fujitsu PRIMERGY RX600 S4 User Manual

Chapter 4 Operations after OS Installation
4.5 Notes before Operating the
Server
This section explains the settings required before starting to operate the server.
For details on the settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
For the settings of the installed application software supplied with the server, refer to the manuals of
each of them.
For notes on the ServerView security, refer to "Security" in "1.1.7 Notes" in the "ServerView User's
Guide".

4.5.1 Auto-run Function from CD/DVD Drives

Perform the following procedures to change the settings of the auto-run function from the CD/DVD
drives after server installation.
1
Make the registry editable, and change the value of AutoRun of the following
registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\CDRom
Set the value of AutoRun to "1" to enable auto-run, or to "0" to disable auto-run.
2
Restart the system.
The setting is enabled after the system restarts.

4.5.2 Drive Letter Assignment in the Expert Mode

In the Expert mode, assignment of a drive letter to a particular partition arbitrarily is not available. Drive
letters specified on Disk Manager in the Expert mode will be sequentially assigned from the first
partition with "C, D, E..." when installation is completed, and an unused drive letter will be assigned to
the CD/DVD drive. To change the drive letter, perform the following procedures after installation.
The drive letters for the system and boot drive are not changeable.
92