Register Reports; Introduction; Z Reports - Sam4s ER-285M Operator's Manual

Register Reports

Introduction

All Management Functions take place with the control lock in the X or Z position. In this
way only those with the correct key will have access to these functions. Some register
operations may be programmed to require the control lock in the X position in order to
operate. All reports require a key that will access the X or Z position.
X & Z Reports
System reports are divided into two basic categories:
•
•
Most reports are available in both categories. Some reports, such as the Cash-in-Drawer
report and the From-To PLU report are available only as X reports.
A complete list of available reports is presented in a chart on the following page.
An example is given for each of these reports in the pages that follow. Those reports that
may be optionally abbreviated through register programming are represented twice. They are
first shown with the option off, giving all totals, and again with the option turned on, showing
the abbreviated version of the same report.
Registers programmed with pop-up clerks must be signed on in the REG control lock
position prior to taking reports.
SAM4s ER-285M Operator's and Program Manual v1.4
X reports, which read totals without resetting
Z reports, which read totals and reset them to zero
Register Reports • 35