System Option Programming - Sam4s ER-285M Operator's Manual

System Option Programming

Refer to the "System Option Table" to review the system options. Read each option carefully
to determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0,
and because your most likely option selections require a status setting of 0, you do not
need to program this section unless you wish to change the default status.
Programming a System Option:
System Option Flowchart
3
138 • Program Mode Reference Guide
1. Turn the control lock to the PGM position.
2. Enter 3 0, press the SUBTOTAL key.
3. Enter a system option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more
than one decision to be made in an address, add the values representing your
choices for each decision and enter the sum. Press the SUBTOTAL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH key to end system option programming.
SUB
0
TOTAL
Option #
Repeat for each
System Option
SUB
X/TIME
TOTAL
Status
SAM4s ER-285M Operator's and Program Manual v1.4
CASH