Setting A Plu Descriptor - Sam4s ER-285M Operator's Manual

Setting a PLU Descriptor

Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three-digit alpha character codes. Go to system option #32 to choose the
method you wish to use. The descriptor code method described here is the default
method.
SAM4s ER-285M Operator's and Program Manual v1.4
1. Turn the control lock to the PGM position
2. To begin the program, enter 3 0 0, press the SUBTOTAL key.
3 0 0
3. Select the PLU you wish to program in one of the following ways:
•
Press a PLU key on the keyboard, or
1
•
Enter the PLU # (up to15-digits) and press the PLU key
Enter the PLU#,
up to 15 digits
4. Enter up to 18 three-character codes from the chart on the next page.
If you make a mistake while entering codes, press CLEAR and begin again at
step #3.
Enter up to 18
three-character
codes
3. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
CASH
SUB
TOTAL
PLU
X/TIME
Quick Start Guide • 29