Saving Reports To An Sd Card; Firmware Update By Sd Card - Sam4s ER-285M Operator's Manual

Backing Up the Program to an SD Card
CAUTION: When backing up and restoring data, the store name must be programmed
in system option #30.
Restore Program from the SD Card
CAUTION: Memory allocation must be set the same as the saved program. Be sure to
print out the memory allocation so that it can be re-enterd before restoring the
program.

Saving Reports to an SD Card

Reports saved are the current X1 readings.

Firmware Update by SD Card

You can use a SD flash memory card to update the register firmware. (When necessary,
update files are supplied by CRS in the form of a file named "ER-280.BIN" and posted on the
dealer pages of www.crs-usa.com. Detailed update instructions will be supplied with the
update package.)
To perform an update:
1. At your PC, create a folder in the root of the SD card named "update".
2. Copy the update file "ER-280.BIN" to the "update" folder.
3. Place the SD card in the SD port of the ER-285M, located on the right side of the
4. Turn the key lock to the S position. (Note that the S position is one position clock-
5. Enter 55, press SUBTOTAL, and then press CASH. The display will indicate that
6. RAM Clear the register. See "Quick Start Step #3: Memory All Clear" on page 21.
198 • Program Mode Reference Guide
1. Turn the control lock to the S position.
2. To backup the program to SD, enter 1 0 0, press the SUBTOTAL key.
1 0 0
1. Turn the control lock to the S position.
2. To load the program to the register from the SD card, enter 1 1 0, press the
SUBTOTAL key.
1 1 0
1. Turn the control lock to the S position.
2. To backup Reports to SD, enter 1 0 1, press the SUBTOTAL key.
1 0 1
register.
wise from the PGM position. The S position is not labeled.)
the card is being read. The register will beep three times when the update is
complete.
SUB
TOTAL
SUB
TOTAL
SUB
TOTAL
SAM4s ER-285M Operator's and Program Manual v1.4