Program 300 - Plu Descriptor Programming - Sam4s ER-920 Operator's And Programming Manual

Program 300 - PLU Descriptor Programming

Program descriptors by typing descriptors on the alpha keyboard overlay or by
entering three digit alpha character codes. To enter descriptors by three digit alpha
character codes you must set system option #25 (See "System Option Programming" on
page 137).
Note: You can program descriptors up to 18 characters, however only the first 16 will
appear on the display.
SAM4s ER-900 Series Operator's & Programming Manual v.1.3
1. Turn the control lock to the PGM position
2. To begin the program, enter 3 0 0, press the SUBTL key.
3 0 0
3. Select the PLU you wish to program in one of the following ways:

Press a PLU key on the keyboard or scan the item.
PLU

Enter the number of the PLU (up to 15 digits) and press the PLU key.
4. If you are programming using an alpha keyboard overlay, type up to 18
descriptors on the overlay and press the X/TIME key.
Type up to 18
descriptor keys
If you are programming using descriptor codes, enter up to 18 three-character
codes and press the X/TIME key. (See "Descriptor Code Chart" on page 133.)
Enter up to 18 three-
character codes
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalize the program.
CASH
SUBTL
PLU
X/TIME
X/TIME
P-Mode Programming • 131