Voice Box Mode; Diagnostics; General Guidance - "Diagnostics" Flow-Chart & Menu Options - Visonic PowerMaster-10 Installer's Manual

5. PROGRAMMING
Enter "RECORD SPEECH", select the menu you wish to perform (see guidance above), then refer to the tables below
which provide you with detailed explanations for each option.
Option
HOUSE IDENTITY
To advance to the next stage in the recording procedure; from the "HOUSE IDENTITY" menu, click
Option
USER #23 VOICE
VOICE LOC. #1

5.8.3 Voice Box Mode

This mode allows you to determine whether two-way voice communication is to be sounded either via an external
speakerphone, via the control panel, or via both.
For the two-way voice communication procedure, follow the instructions below. Additional details and guidance are
provided in section 5.2.
06:CUSTOM NAMES
Enter "VOICE BOX MODE", and then refer to the table below which provides you with the options.
VOICE BOX MODE

5.9 Diagnostics

5.9.1 General Guidance – "Diagnostics" Flow-Chart & Menu Options
The DIAGNOSTICS menu enables you to test your system and to verify proper operation of your PowerMaster panel,
wireless devices attached to it and the communication (GSM/GPRS) modules.
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent system
maintenance. A device should not be installed in location where signal strength is "poor". If you get "poor" signal
strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal strength is received. This
principle should be followed throughout the diagnostic test procedure.
The diagnostic test process is shown below.
54
Instructions
You can record a message to be announced automatically when events are reported to
private telephones.
While in "RECORD SPEECH", press
alternates with "REC-<2> PLAY-<5>" (this means, press the
button to play recording).
To initiate the recording procedure, press the
message; "RECORD A MESSAGE" appears momentarily and then changes to
"TALK NOW 
" (the square boxes slowly disappear, one by one, until the end of the
recording time).
At the end of the recording process, the panel will display the following:
"RECORDING ENDED". Release the
Note: To check the recorded message, press the
Instructions
You can record ten user names and assign them to users 23-32. In case of event, the
relevant user name will be added to the message that will be reported via the telephone.
Record user names for 23-32; the procedure is identical to the "HOUSE IDENTITY" recording
procedure described above. Click
You can record user terms 1- 5 (for example, Living room, Library, etc.), and assign them to
specific zones. These names are useful if none of the 26 fixed zone names are found
suitable for a certain zone. When done, press
Record user terms 1-5; the procedure is identical to the "HOUSE IDENTITY" recording
procedure described above. Click
1
  
VOICE BOX MODE
Define whether two-way voice communication is to be sounded either via the external
speakerphone ("VOICE BOX ONLY"), via the control panel ("NO VOICE BOX"), or via both
("VOICE BOX MIXED").
Options: NO VOICE BOX; VOICE BOX ONLY and VOICE BOX MIXED (default)
; the display now reads "HOUSE IDENTITY" and
button continuously to record your
button.
button and listen to the playback.
to navigate between user name numbers.
to return.
to navigate between user term numbers.
D-303222 PowerMaster-10/30 G2 Installer's Guide
button to record and the
.