Removing The Media Bezel - IBM System x3350 Type 4192 Problem Determination And Service Manual

10. Reconnect the external cables and the power supply.
11. Turn on the peripheral devices and the server.

Removing the media bezel

To remove the media bezel, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the cover (see "Removing the cover" on page 61).
4. Remove the hard disk drive cage (see "Removing and installing a disk drive
5. Remove fan number 3 (see "Removing a hot-swap fan assembly" on page 85).
6. Disconnect the video cable from the connector on the system board.
92
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
5. Align the holes in the top of the drive cage with the holes in the top of the
chassis; then, insert the mounting screws that secure the drive cage to the
chassis.
Mounting screws
6. Reconnect the cables to the system board and the power backplane.
7. Install the removed drives (see "Removing and installing internal drives" on
page 72).
8. Install the cover (see "Installing the cover" on page 62).
9. Slide the server into the rack.
on page 57.
all external cables.
cage assembly" on page 89).
2.5" drive cage