Installing The 2.5-Inch Sas Backplane - IBM System x3350 Type 4192 Problem Determination And Service Manual

10. If you are instructed to return the backplane, follow all packaging instructions,

Installing the 2.5-inch SAS backplane

To install the replacement 2.5-inch SAS backplane, complete the following steps:
Mounting channel
98
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
5. Disconnect the power cable from the power backplane.
6. Disconnect the signal cable from the mini-SAS/SATA controller.
7. Remove the disk drive cage (see "Removing a 2.5-inch disk drive cage
assembly" on page 91).
Power cable
2.5 in. disk drive
backplane
Locking tab
Mounting channel
8. Press the locking tabs toward each other and lift the backplane off the disk
drive cage.
9. Disconnect the power cable and the signal cable from the disk drive
backplane.
and use any packaging materials for shipping that are supplied to you.
Power cable
2.5 in. disk drive
backplane
Locking tab
Signal cable
Locking tab
Mounting channel
2.5 in. disk drive cage
Signal cable
Locking tab
Mounting channel
2.5 in. disk drive cage