Removing The Cd-Rw/Dvd Drive Interposer Card - IBM System x3350 Type 4192 Problem Determination And Service Manual

Drive handle
The following illustration shows the 3.5-inch hard disk drive server model.
Drive handle
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Place the drive handle in the open position (perpendicular to the drive).
3. Align the drive assembly with the guide rails in the bay.
4. Gently push the drive assembly into the bay until the drive stops.
5. Push the tray handle to the closed (locked) position.
6. Check the hard disk drive status LED and activity LED to verify that the drive is
Note: If the server has a RAID controller or adapter, you might have to reconfigure
the disk arrays after you install hard disk drives. See the RAID documentation on
the IBM System x Documentation CD for information about RAID adapters.

Removing the CD-RW/DVD drive interposer card

To remove the CD-RW/DVD drive interposer card complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Open the fan door.
4. Remove the CD-RW/DVD drive (see "Removing a CD-RW/DVD drive" on page
76
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
Drive-tray assembly
Hard disk drive assembly
on page 57
operating correctly.
on page 57.
all external cables.
72).
SAS hard disk
drive backplane