Installing The Center Air Baffle - IBM System x3350 Type 4192 Problem Determination And Service Manual

4. Lift the baffle up slightly, making sure that the pins come out of the holes on the
5. Slide the cable out of the cable routing slot. Make sure that you do not
6. Lift the baffle out of the server.
7. If you are instructed to return the baffle, follow all packaging instructions, and
Attention:
the server. Operating the server with the air baffles removed might damage server
components.

Installing the center air baffle

To install the replacement air baffle that is near the center of the server, complete
the following steps:
1. Align the pins on the bottom of the baffle with the mounting holes in the system
2. Slide the operator panel and the media backplane cables into the cable routing
Air baffle
Cable routing slot
system board.
disconnect or loosen the cable.
use any packaging materials for shipping that are supplied to you.
For proper cooling and airflow, replace the air baffles before turning on
board.
slot.
Baffle pins
Baffle mounting
holes
Chapter 4. Removing and replacing server components
65