15. Lift the system board slightly so that it disengages from the locator pin.
16. Slide the system board slightly toward the front of the server.
17. Lift up the left side of the system board.
18. Lift the rest of the system board and carefully remove it from the server, being
19. If you are instructed to return the system board follow all packaging
Installing the system board
Note: When you reassemble the components in the server, be sure to route all
cables carefully so that they are not exposed to excessive pressure.
To reinstall the system board, complete the following steps:
112
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
careful not to disturb any surrounding components.
instructions, and use any packaging materials for shipping that are supplied to
you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 57.
2. Align the system board with the chassis and install the eight screws that you
removed previously.
3. Install the microprocessor and microprocessor heat sink (see "Installing a
microprocessor" on page 104).