Installing The Media Bezel - IBM System x3350 Type 4192 Problem Determination And Service Manual

7. Remove the two mounting screws in the top of the media bezel.
8. Rotate the media bezel downward to disengage it from the chassis and carefully
9. If you are instructed to return the media bezel, follow all packaging instructions,

Installing the media bezel

To install the replacement bezel, complete the following steps:
Video cable screws
pull the video cable out of the server. Remove the cable and the bezel from the
server.
and use any packaging materials for shipping that are supplied to you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 57.
2. If you need to attach the video cable to the bezel, use the two video cable
screws that came with the kit.
Video cable screws
3. Insert the video cable through the opening in the front of the chassis.
4. Insert the tabs on the bottom of the bezel into the corresponding holes in the
bottom of the chassis.
5. Rotate the top of the bezel up to the chassis.
6. Attach the bezel to the chassis using the two mounting screws you removed
previously.
Mounting screws
Media bezel
Mounting screws
Media bezel
Chapter 4. Removing and replacing server components
93