Installing A Power Supply - IBM System x3350 Type 4192 Problem Determination And Service Manual

CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
To remove a hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If only one power supply is installed, turn off the server and peripheral devices
3. If the server is in a rack, at the back of the server, pull back the cable
4. Disconnect the power cord from the power supply.
5. Press and hold the orange release tab down and pull the power supply out of
6. If you are instructed to return the power supply, follow all packaging instructions,

Installing a power supply

Statement 8:
84
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
on page 57
and disconnect all power cords.
management arm to gain access to the rear of the server and the power supply.
Power supply
the server.
and use any packaging materials for shipping that are supplied to you.
Power-supply
release tab
Power-supply handle