Removing An Optional Serveraid-Mr10I Sas/Sata Controller; Installing An Optional Serveraid-Mr10I Sas/Sata Controller - IBM System x3350 Type 4192 Problem Determination And Service Manual

Removing an optional ServeRAID-MR10i SAS/SATA controller

To remove an optional ServeRAID-MR10i SAS/SATA controller, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 61).
4. Disconnect the hard disk drive signal cable from the connector (J8) on the
5. Grasp the riser-card assembly at the rear edge, and lift to remove it from the
6. Carefully grasp the controller by its top edge or upper corners, and pull the
7. If you are instructed to return the controller, follow all packaging instructions,

Installing an optional ServeRAID-MR10i SAS/SATA controller

For a list of supported optional devices for the server, see http://www.ibm.com/
servers/eserver/serverproven/compat/us/
To install a replacement ServeRAID-MR10i SAS/SATA controller, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Touch the static-protective package that contains the controller to any unpainted
82
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
on page 57.
all external cables.
controller.
Optional ServeRAID-MR10i
SAS/SATA controller
server. Place the riser-card assembly on a flat, static-protective surface.
controller from the riser-card assembly.
and use any packaging materials for shipping that are supplied to you.
on page 57.
metal surface on the server. Then, remove the controller from the
static-protective package. Avoid touching the components and gold-edge
connectors on the controller.
Expansion-
slot cover
Riser-card
assembly
Expansion
slot
Riser-card
connector