Noread Message - Microscan MS-7100 User Manual

Noread Message

Default: NOREAD
Options: Up to seven ASCII characters
Allows you to define any combination of ASCII characters (except a NUL)
up to seven characters as the noread message.
The noread message, if enabled and if no bar code label has been decoded,
will be transmitted to the host at a timeout or the end of a read cycle.
Noread Message (enable/disable)
Default: Enabled
Options: Enabled, Disabled
Note : If Noread Output is enabled, the noread message will only output if Bar
Code Output (page 2-17) is also enabled.
Allows you to enable or disable the noread message.
Bar Code Output
Default: Enabled
Options: Enabled, Disabled
Allows you to choose whether or not to output label data or a noread to the
host. When disabled, a label is decoded and the read cycle transpires as
usual, but neither label data nor the noread message is transmitted to the
host. Scanner counters are updated, and the current number of good reads
or noreads can be obtained via operational commands.
When to Output
Default: As Soon As Possible
Options: As Soon As Possible, End of Read Cycle
Allows you to choose when bar code data is sent to the host.
Selecting: Has this effect:
As Soon As Possible Causes bar code data (good reads) to be transmitted
immediately upon a good decode.
End of Read Cycle Causes bar code data output to be delayed until the
end of the read cycle.
MS-7100/7180 Industrial Scanner User's Manual
Operations Menu
2-17