Microscan MS-7100 User Manual page 33

For example, to enable LRC (see
Redundancy Check" on page 2-9) use the following command line path:
Main —> Communications
Main —> Operations
Main —> Code Types
Main —> User Outputs
Communications —Host Protocol
Communications —> Host Port
Communications —> Aux Port
Host Protocol —> Protocol
Host Protocol —> Preamble = ^M
Host Protocol —> Preamble = Enabled
Host Protocol —>Postamble = ^M^J
Host Protocol —>Postamble = Disabled
Host Protocol —>LRC
Host Protocol —>Response Timeout
Host Protocol —> Intercharacter Delay
Host Protocol —> LRC = Disabled
Host Protocol —> LRC = Enabled
To view LRCs new status in the menu, press M to refresh the screen. To
return to the Main menu, press M again. You can make additional changes
within another menu before exiting the program. Simply follow the same
method of scrolling to and selecting each main topic, then its subtopics, until
you reach the parameter you want to change. Remember, to return to the
Main menu at any time, press ESC (Escape key) and M.
Some parameters are user defined, in which case they prompt you with an
arrow for data, such as:
At the prompt, redefine the parameter within the allowable range, and press
CR to enable.
MS-7100/7180 Industrial Scanner User's Manual
figure 2-2 on page 2-5 and "Longitudinal
From the Main menu, press CR at the
Communications prompt (this is the
first prompt displayed in the Menu
Configuration Program) to access the
Communications menu.
Since LRC is a subtopic of Host
Protocol, press CR to access the
Host Protocol parameters.
Protocol is the first parameter under
Host Protocol. Press SP until you
reach LRC, then press CR.
To enable LRC, press CR, SP, and
CR.
2-3