Microscan MS-7100 User Manual page 97

Industrial scanner
Table of Contents

Advertisement

Chapter
5
Summary of Operational Commands................................................... 5-2
Program Management Commands...................................................... 5-3
Device Control Commands .................................................................. 5-3
Code Type Commands ........................................................................ 5-4
Counter Commands............................................................................. 5-4
Test Commands................................................................................... 5-5
Status Commands ............................................................................... 5-5
Master Label Commands ..................................................................... 5-5
This chapter describes the scanner's serial operational commands and their
functions.
On-line serial operational commands are sent from the host to the scanner to
carry out routine operations "on the fly" as distinguished from serial configura-
tion commands that are generally used in initial setup.
Operational commands are always preceded by a < left angle bracket symbol
(unless redefined by Command Start Character command) and followed by a >
right angle bracket symbol.
1. The scanner will only recognize a <D> serial command (Enter Menu Configuration Program)
from an auxiliary terminal.
2. Command start character by default is a left angle bracket, <. It may be redefined by menu or
serial command. However, the end character, a right angle bracket, >, cannot be changed.
MS-7100/7180 Industrial Scanner User's Manual
Operational
Commands
Chapter Contents
1
2
5-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MS-7100 and is the answer not in the manual?

This manual is also suitable for:

Ms-7180

Table of Contents