Summary Of Operational Commands; Table 5-1 Operational Commands - Microscan MS-7100 User Manual

Chapter 5 Operational Commands

Summary of Operational Commands

Command Type
Program
Management
Device
Control
Code Type
Counter
Test
Status
Master Label
* Can also be accomplished in configuration menu and serial configuration command.
5-2
MS-7100/7180 Industrial Scanner User's Manual

Table 5-1 Operational Commands

Command Result
<A> Software Reset (does not save for power-on)
<D> Enter Configuration Mode
<Z> Save Configuration for Power-on
<t> Enter Calibration Setup menu
Autocalibration initiation
<KT>
Autocalibration factory default
<KTD>
<KTZ> Save autocalibration
<Bdata> Echo Data to Aux Monitor
<H> Enable Laser Scanning
<I> Disable Laser Scanning
<L> Host Relay Driver
<P> Autodiscriminate All Codes
<Q> Enable Code 39 Only*
<R> Enable Codabar Only*
<S> Enable I 2 Of 5 Only*
<N> Noread Counter
<O> Noread Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Match Code (or Good Read) Counter
<W> Match Code Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
<C> Enter Read Rate Test
<m> Enter Scan Rate Test
<J> Exit Read Rate or Scan Rate Test
<#> Display Software Part Number
<!> Display Checksum of EPROM
<E> Enable Match Code Option*
<F> Disable Match Code Option*
<G> Store Next Label Scanned as Master Label
<)XXXX)> Download Master Label Information
<)> Request Master Label Information
<))> Delete Master Label Information