Match Length - Microscan MS-7100 User Manual

Match Start Position
Default: 0
Options: 0 to 31
Match Start Position must be set to 1 or greater to enable this feature.
Defines the first character in the label (from left to right) that will be com-
pared with those of the master label when Match Code Type is set to
Enabled or Sequential. For example, if you set Match Start Position to 3, the
first 2 characters read in the label will be ignored and only the 3rd and sub-
sequent characters to the right will be compared, up to the number of char-
acters specified by Match Length.

Match Length

Default: 1
Options: 1 to 31
Defines the length of the character string that will be compared with that of
the master label when Match Code Type is set to Enabled or Sequential
and Match Start position is set to 1 or greater. For example, If Match Length
is set to 6 in a 10 character label, and Match Start Position is set for 2, only
the 2nd through 7th characters (from left to right) will be compared.
Wild Card Character
Default: * (asterisk)
Options: Any ASCII character
Allows you to define the wild card character that can be used when defining
a master label.
Master Label Entry
With Match Code Type set to Enabled, Sequential, or Wild Card, a master
label can be entered in four ways:
1. By typing in from the keyboard at the command line of the Operations
menu under Match Code Master.
2. With New Master Pin enabled (see
ground (or by momentarily pressing the New Master button on the IB-
105) will save the next label read as the master label.
3. Sending serial command <G> allows the next label read to be the mas-
ter label.
4. Sending a serial command in the format <)XXXX)> downloads data as
the master label.
MS-7100/7180 Industrial Scanner User's Manual
Operations Menu
page 2-34), toggling scanner pin 12 to
2-21