Table of Contents
Advertisement
Response Timeout
Response Timeout
Usage:
Only used when a response is required from the host. While in Multidrop, if
the Imager does not receive an ACK or NAK from the host after sending
polled data, it will act on a fault. The reader can be set to wait indefinitely by
setting Response Timeout to zero.
Definition:
The time that the Imager will wait before timing out if ACK, NAK, and ETX
are enabled, and a host response is expected.
Serial Cmd:
<K143,response
Default:
12
(in 1mS increments)
Options:
0 to 255 (A zero (0) setting causes an indefinite wait.)
Note: See
USB HID Interface
3-20
timeout>
on page 3-23 for protocol information relating to USB.
MS-4 Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-4 and is the answer not in the manual?
Questions and answers