Table of Contents
Advertisement
Read Rate
Read Rate
Read Rate by ESP
You can access Read Rate from the Utilities menu under the Read Rate tab.
To see the number of decodes per second, click the Decodes/sec radio button and click
the Start button.
To see the percentage of decodes, click the Percent radio button and then the Start button.
To end a read rate test, click the Stop button (the Start button becomes a Stop button
during an active read rate test.)
Read Rate by Serial Command
Enter Decodes / Second Test
Sending
<C>
instructs the Imager to transmit the decodes per second and symbol data (if
any). The decode rate can vary dramatically due to the angle and location of the symbol in
relation to the field of view. This test is very useful in aligning and positioning the Imager
during setup.
Enter Percent Test
Sending
<Cp>
instructs the Imager to transmit the percentage of decodes and any
decoded symbol data.
End Read Rate Test
Sending
<J>
ends both the Percent test and the Decodes/Second test.
13-4
MS-4 Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-4 and is the answer not in the manual?
Questions and answers