Microscan MS-4 User Manual page 145

Separator Character (UPC / EAN)
Note: If Separator Character has been changed to any other character and you wish to
redefine the separator as a comma, you will need to use ESP.
Usage: As required by the application.
Definition: Allows the user to change the separator character from a comma to a new
character.
Serial Cmd: <K473,UPC status,EAN status,supplementals status,separator status,
separator
Default: , (comma)
Options:
Any ASCII character.
Important: The ASCII characters <, >, and
For <: <K473h,,,,,3C>
For >: <K473h,,,,,3E>
,
For : <K473h,,,,,2C>
See ASCII Character Entry Modifier
enter ASCII characters as hex values.
Note: Whenever Separator Character is defined as a comma (,) sending a
command will return the current settings, including the separator character comma which
appears after the separator status comma.
Supplemental Type (UPC / EAN)
Usage: As required by symbology used in application.
Definition: Allows the user to select 2 character or 5 character supplements, or both.
Serial Cmd: <K473,UPC status,EAN status,supplementals status,separator status,
separator
Default: Both
Options: 0 = Both
Both
Either 2 character or 5 character supplementals will be considered valid.
2 Characters Only
Only two character supplementals will be considered valid.
5 Characters Only
Only five character supplementals will be considered valid.
MS-4 Imager User's Manual
character,supplemental type,format UPC-E as UPC-A>
,
can only be entered as hex pairs:
on page 3-32 for a detailed explanation of how to
character,supplemental
1 = 2 characters only
type,format UPC-E as UPC-A>
2 = 5 characters only
Symbologies
<K473,s?>
6-23