Table of Contents
Advertisement
Auxiliary Port Connections
Command Processing Mode
Usage:
Allows a user to send configuration settings from the host port to the auxiliary
port.
Definition:
When enabled, Command Processing Mode allows commands to be
entered via the auxiliary port and direct externally triggered read cycle data
in one of two ways:
• Bar code data, including the serial trigger (if used), will be transmitted to
the last port from which a command was sent.
• If the last command came from the host port, then externally triggered
read cycle data will only be output to the host port.
Serial Cmd:
<K101,aux port
status,daisy chain i.d.>
Options:
5 = Command Processing
3-16
mode,baud rate,parity,stop bits,data bits,daisy chain i.d.
MS-4 Imager User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-4 and is the answer not in the manual?
Questions and answers