Additional Notes About Calibration - Microscan MS-4 User Manual

Additional Notes about Calibration

The following conditions apply to the Imager's calibration process. Some of these items
are noted at various points throughout this section, or in other sections of the Imager's
documentation.
1. The Mirrored Image
2. Background Color
3. If Window of Interest (WOI) Framing
when calibration begins. If WOI Framing is disabled, the current WOI configuration
will be used for the
4. IP Mode <K527>
5. Threshold Mode
successful calibration, Threshold Mode will remain set to Adaptive regardless of its
previous setting. Otherwise, the value will revert to its original state.
6. If Symbol Type
Range Mode Status (Interleaved 2 of 5)
Interleaved 2 of 5 symbols to be decoded. If an Interleaved 2 of 5 symbol is decoded
during calibration, then symbol length # 1 will be set to the decoded symbol length at
the end of calibration. Otherwise, the symbol lengths will be restored to their original
configurations.
7. The symbol size, dimension, and orientation parameters of the
and Bad Symbol
will be updated if calibration is completed successfully.
8. All symbol types that were enabled before calibration will still be enabled after calibration.
For example, if Data Matrix ECC 200 was enabled before calibration, and the calibration
routine was performed on a Code 128 symbol, then after calibration is completed both
Data Matrix ECC 200 and Code 128 will be enabled.
9. The calibration process does not modify the global
global Composite status must be configured properly before calibration.
10. If the user requires calibration of a
that symbology must be enabled and configured appropriately before calibration.
11. UPC Supplementals
12. The Search Pass
tures. However, when the search process is completed, the WOI will be reduced to
include only the symbol of interest and some additional boundary area.
MS-4 Imager User's Manual
parameter <K514>
<K451> is calibrated.
Search Pass.
will not be altered during calibration.
<K512> will be set to Adaptive during calibration. At the end of a
is enabled for calibration (Autodiscriminate), then Interleaved 2 of 5
Message, and 2D Symbology Qualification
stacked
will be disabled during calibration.
process will use the configurable Window of Interest for image cap-
is not part of the calibration process.
is enabled, the WOI will be set to full frame
<K472> will be enabled. This allows variable-length
Composite
symbology <K482>, <K483>, or <K484>,
Calibration
No Symbol Message
command <K718>
status <K453>. The
4-17