Microscan MS-4 User Manual page 36

Menu Toolbar
Advanced Tab
The Auto Sync dialog at the top of the Advanced tab allows you to determine whether
Auto Sync will be automatically enabled in sections of ESP where it is used, or if it will ask
you before it enables Auto Sync functions.
Always Ask Before Auto Sync Occurs
If you check this option box, you are then able to determine what specific Auto Sync
functions will be enabled. Receive Settings from the Reader will automatically send
the Imager's settings to ESP when Auto Sync is enabled. Send ESP Settings to the
Reader will automatically send all Imager configuration settings chosen in ESP to the
Imager. Do Not Send or Receive Settings creates a condition in which Auto Sync will
not send Imager settings to ESP, or send ESP settings to the Imager.
Show Targeting Pattern During Calibrate and Locate
Allows you to determine whether the blue LED target pattern will be on or off during the
Locate and Calibrate routines.
Send XON with Autoconnect
Sends an XON (Begin Transmission) command to the Imager before starting the Autoconnect
routine.
2-10
MS-4 Imager User's Manual