Default / Reset / Save - Microscan MS-4 User Manual

Default / Reset / Save

Default / Reset / Save

Understanding and controlling your Imager's active, saved, and default settings is critical
to its successful operation.
Reset
Reset and recall Microscan defaults
Reset and recall power-on parameters
Reset and recall customer default parameters
Save current settings for power-on
Save current settings as customer default
parameters for power-on
Recall Microscan default parameters and
save for power-on
Recall customer default parameters and save
for power-on
a. When you right click in a menu tree and select Default Current Menu Settings or Default All ESP
Settings, it is important to note that only ESP settings are defaulted. To save these defaults to the
reader itself, you need to follow up with a Save to Reader, Send and Save command.
b. Only available in ESP if enabled under the Options pulldown menu.
Resets
Resets ("A" commands) affect only the current settings (active memory) and are not saved
for power-on.
Saved for Power-on
Power-on parameters ("Z" commands) are saved to NOVRAM and recalled and loaded
into current parameters when power is cycled to the Imager or the
sent.
Defaults
Defaults are Microscan firmware settings or saved customer settings that can be recalled,
either by software or hardware reset.
13-18
Function
ESP (first, right
Serial
click in any menu
Cmd
a
tree)
Save to Reader,
<A>
Send No Save
<Ard> No
<Arp> No
<Arc> No
Save to Reader,
<Z>
Send and Save
Save to Reader,
Send and Save
<Zc>
Customer Defaults
for Power-On
<Zrd> No
<Zrc> No
<Arp>
MS-4 Imager User's Manual
EZ Button
No
No
No
No
No
No
b
No
Press and
hold while
powering on
Imager
command is