Power-On/Reset Counts - Microscan MS-4 User Manual

Power-On / Reset Counts
Note: Power On / Reset Counts is a read only command.
Power-On
Serial Cmd: <K406,power-on,resets,power-on saves,power-on flash saves>
Power-On uses a 16-bit counter that increments each time the Imager is powered-on.
Resets
Serial Cmd: <K406,power-on,resets,power-on saves,power-on flash saves>
Resets uses a 16-bit counter that increments each time the Imager is reset. This value is
reset at power-on.
Power-On Saves
Serial Cmd: <K406,power-on,resets,power-on
Power-On Saves uses a 16-bit counter that increments each time an Imager setting is
saved for power-on with a
Power-On Flash Saves
Serial Cmd: <K406,power-on,resets,power-on
Power-On Flash Saves uses a 16-bit counter that increments each time an Imager setting
is saved to the customer parameter section of flash memory with a
MS-4 Imager User's Manual
<Z> command.
saves,power-on flash saves>
saves,power-on flash
<Zc>
I/O Parameters
saves>
command.
7-41