Response Timeout - Microscan MINI Hawk User Manual

Response Timeout

Response Timeout

Only used when a response is required from the host. While in Multidrop, if
Usage:
the imager does not receive an ACK or NAK from the host after sending
polled data, it will act on a fault. The reader can be set to wait indefinitely by
setting Response Timeout to zero.
The time that the imager will wait before timing out if ACK, NAK, and ETX
Definition:
are enabled, and a host response is expected.
<K143,response
Serial Cmd:
(in 1 ms increments)
Default: 12
0 to 255 (A zero (0) setting causes an indefinite wait.)
Options:
Note: See
USB HID Interface
3-20
timeout>
on page 3-23 for protocol information relating to USB.
MINI Hawk High Performance Imager User's Manual